Komponenten · Nachleuchtend

Die Karte, die man um 3 Uhr nachts findet

Eine nachleuchtende Beschichtung auf Karten-PVC lädt sich am Zimmerlicht auf und leuchtet stundenlang — ohne Batterien, ohne Elektronik, ohne Störung des Chips.

Nachleuchtende PVC-Folien- und Plattenrollen

Nachleuchtendes PVC kombiniert eine Leuchtbeschichtung mit demselben 80–86 °C Karten-PVC darunter, als Folie und Platte von 70 bis 810 μm. Auf Schlüsselkarten entsteht ein Leuchtlogo, das Gästen im Gedächtnis bleibt; als flammhemmendes Beschilderungsmaterial hält es Flur-Leitsysteme sichtbar, wenn das Licht ausfällt.

Höhepunkte

Leuchtet ohne Strom

Speichert Umgebungslicht und gibt es stundenlang ab — lädt endlos nach, nichts kann ausfallen.

Karten-PVC darunter

Vicat 80–86 °C, ≥ 40 MPa — laminiert und codiert wie Standardmaterial.

Für Nässe und harten Einsatz

Flammhemmend, salzwasser- und reinigerbeständig — Pools inklusive.

Photoluminescent PVC — technical data

What it is
Card-grade PVC coated with a photoluminescent layer — charges in ambient light, glows in the dark with no power source
Sheet range
70–810 μm film and sheet — from thin laminating film to rigid sign-grade stock
Glow behaviour
Absorbs room light, then re-emits for hours in darkness; recharges indefinitely with no electronics
Card properties
Vicat 80–86 °C, tensile ≥ 40 MPa, matte Rz 4–10 μm, wetting ≥ 38 dyn/cm — standard card PVC underneath the glow
Durability
Flame-retardant, salt-water and detergent resistant — pool areas and housekeeping chemicals are in spec
Build
Glow layer + white PVC base; film version adds adhesive and release liner for application to signage
Uses
Glow accents on key cards and fobs, low-light wayfinding strips, emergency exit signage in corridors and stairwells

Inside photoluminescent PVC

The glow is a coating, not a chemical trick inside the resin: a photoluminescent layer over a white PVC base that reflects the stored light outward. On a key card it makes the card findable in a dark room; on corridor signage it keeps exit routes visible in a power cut — with the fire-safety bonus that the base film is flame-retardant.

Standard card PVC in daylight — a soft green glow when the lights go out

  1. Photoluminescent layer Charges in light, glows for hours in darkness
  2. White PVC base · 70–810 μm Reflects stored light outward; prints normally
  3. Adhesive + release liner (film version) For application to signage and fixtures

When luminous PVC is the right call

  • A findable card: a glow accent means the key card on the nightstand is visible at 3 a.m. without waking a partner.
  • Guest-safety wayfinding: corridor and stairwell strips that stay visible in outages, with no wiring and no batteries.
  • A memorable signature: a glow logo is the kind of detail guests photograph — and it costs a coating, not a chip.

Luminous PVC questions

How long does the glow last?

Hours, tapering from bright to soft — brightest in the first hour after lights-out, then a gentle glow deep into the night. Charging is automatic: any ambient room light restores it, and the photoluminescent pigment does not wear out with cycles.

Does a glow card need batteries or electronics?

No. The effect is purely physical — the pigment stores photon energy and re-emits it. Nothing to charge, replace or fail, and it adds no thickness or RF interference to the card build.

Can we use it as design accent rather than a full glow card?

That is the usual spec: a glow logo, edge stripe or room-number panel on an otherwise standard card. The luminous layer applies where the artwork calls for it, so the daylight design stays fully on-brand.

Is the signage version suitable for fire-safety wayfinding?

The film is flame-retardant and photoluminescent wayfinding is an established practice for low-level exit marking. Code requirements vary by jurisdiction, so treat our signage stock as a supplement to — not a replacement for — your certified emergency systems, and check local regulations.

Bestellung starten

Brauchen Sie Schlüsselkarten, die beim Check-in einfach funktionieren?

Nennen Sie uns Ihre Schlossmarke und Menge — Sie erhalten ein werksdirektes Angebot und ein kostenloses Musterpaket, um es vor der Bestellung in Ihren eigenen Schlössern zu testen.